Device Driver(s) for various motor and lighting (LED) control products are currently available below as sample one-way drivers (using RS-232-C connectivity). In some cases, drivers are available as 1-way wizards (again using RS-232-C connectivity). . In addition, it is expected that additional VIA TOOLs wizards will be made available directly through Elan. Once these drivers are available, information as to their availability will be announced here. However, with the downloadable templates available on this page, any Elan authorized dealer can easily integrate the following products quickly with the tools available today.
| Model |
Functions |
Sample Screens / Downloads |
IMC-100 (via IBT-100 serial interface)
Single Motor Controllers
|
Controls device(s) using RS-232-C communication.
Controls motor direction (up,down, and stop).
Controls intermediate presets (IMC-100T).
Controls multipe zone, group, and node (Z.G.N) addresses.
Controls setup, browse, and help menus.
|
Sample Screens
Module (1 K)
[Date Code: 07/25/2010]
Templates (3 K)
|
ILC-100 (via IBT-100 serial interface)
LED Lighting Controller
|
Controls device(s) using RS-232-C communication.
Controls lighting state (ON/OFF).
Controls lighting presets (P1-P8).
Controls lighting effects (Effect #1).
Controls multipe zone, group, and node (Z.G.N) addresses.
Controls setup, dissolve rate and sequence rate.
|
Sample Screens
Module (2 K)
[Date Code: 07/25/2010]
Templates (5 K)
|
IMC-100 (via eNode-Ethernet Adapter)
Single Motor Controllers
|
Controls device(s) using UDP communication over Ethernet.
Controls motor direction (up,down, and stop).
Controls intermediate presets.
Controls multipe zone, group, and node (Z.G.N) addresses.
Controls setup, browse, and help menus.
|
Sample Screens
Module (1 K)
[Date Code: 07/25/2010]
Templates 32 K)
|
|
ILC-100 (via eNode Ethernet Adapter)
LED Lighting Controller
|
Controls device(s) using UDP communication over Ethernet.
Controls lighting state (ON/OFF).
Controls lighting presets (P1-P8).
Controls lighting effects (Effect #1).
Controls multipe zone, group, and node (Z.G.N) addresses.
Controls setup, dissolve rate and sequence rate.
|
Sample Screens
Module (2 K)
[Date Code: 07/25/2010]
Templates (5 K)
|
|
BRIC (via built-in serial interface)
3-motor Master Controller System
|
Controls device using built-in RS-232-C communication.
Utilizes Elan Built-in 1-way wizard available in Via Tools.
Controls two separate motor digitally with up, down,and stop controls.
Controls third motor (traditionally a door motor) with up and down controls.
Controls multipe BRIC addresses (unit 1-4).
Controls up to 8 preset multi-motor presets.
|
Sample Screens
Module (TBD K)
[Date Code: Current]
Templates (3 K)
|
